Rev 1.0
Mellanox Technologies
10
The following is an example of the output:
Interface eth0 state
Admin up: yes
Link up: yes
IP address: 192.168.10.6
Netmask: 255.255.255.0
Speed: 100Mb/s (auto)
Duplex: full (auto)
Interface type: ethernet
Interface source: physical
MTU: 1500
HW address: 00:00:50:3A:8E:80
Comment:
RX bytes: 123102
RX packets: 1271
RX mcast packets: 0
RX discards: 0
RX errors: 0
RX overruns: 0
RX frame: 0
TX bytes: 122850
TX packets: 1119
TX discards: 0
TX errors: 0
TX overruns: 0
TX carrier: 0
TX collisions: 0
bridge-112428#
Step 4.
Before attempting a remote (for example, SSH) connection to the switch, check the
eth0 interface configuration. Specifically, verify the existence of an IP address. To
check the current eth0 configuration, enter the following commands:
switch-1 > enable // Enter ‘enable’ mode of CLI
switch-1 # show interface eth0 // # indicates ‘enable’ mode
The following is an example of the output:
Interface eth0 state
