Replacing a Tall Bracket With a Short Bracket
Rev 1.0
Mellanox Technologies
24
Note: If the old gasket is still on the card, remove it before installing the new bracket. Make sure
that only one gasket is used.
3. Place the bracket onto the card until the screw holes line up.
Note: Do not force the bracket onto the card. You may have to gently push the LEDs using a
small screwdriver to align the LEDs with the holes in the bracket.
4. Using the screws and washers saved from the procedure above step 1. place the screws and
washers into the holes and screw them in snug.
Figure 12: Placing the Bracket on the Card
5. Make sure that the LEDs are aligned onto the bracket holes.
6. Use a torque driver to apply up to 2 lbs-in torque on the screws.
Gasket in
place on the
bracket.
