Melitta Purista, Руководство по эксплуатации

Страница: 35 / 308

Basic operation
35
GB
ū Install the appliance on a stable, flat
and dry surface.
ū Do not install the appliance in the vicin-
ity of sinks or the like.
ū Do not install the appliance on hot
surfaces.
ū Install the appliance at a sufficient
distance (approx. 10 cm) from the wall
and other objects. The space above the
appliance should be at least 20 cm.
ū Route the power cable so it cannot be
damaged by edges or hot surfaces.
3.3 Connecting the appliance
Observe the following instructions:
ū Check that the supply voltage matches
the operating voltage specified in the
technical data (see table Technical data
on page 51).
ū Only connect the appliance to a prop-
erly installed earthing contact socket. If
in doubt, consult a specialist electrician.
ū The earthing contact socket must have
a fuse of at least 10 A.
3.4 Switching on the appli-
ance for the first time
Once you switch on the appliance for the
first time, the appliance performs auto-
matic rinsing. Hot water flows out of the
outlet. The appliance is vented.
Information
ū We recommend pouring away the first
two cups of coffee after initial start-up.
ū If you want to use a water filter, only
insert this after starting up for the first
time.
15
Fig. 4: ON/OFF button
Requirement: The appliance has been
installed and connected.
1. Place a vessel beneath the outlet.
2. Press the ON/OFF button (15) .
»
The Ready display lights up
briefly.
»
The Water display lights up and
requests you to fill the water tank.
3. Open the lid of the water tank and
pull the water tank upwards out of the
appliance by the handle.
4. Rinse out the water tank with clean
water. Fill the water tank with fresh
water.
5. Insert the water tank into the appliance
from above and close the lid.
»
The Vent display lights up and
requests you to vent the appliance.
6.
Press the "Coffee strength" button.
» Water flows into the drip tray.
» The appliance heats up and hot
water flows out of the outlet.
7. Once no more water flows out of the
outlet, the Coffee bean display lights up.
» The appliance is vented.
8. Fill coffee beans into the bean con-
tainer (see section 4.3 Filling coffee
beans into the bean container on
page 11) .
9. As required, you can now either
a) set the water hardness (see sec-
tion 6.3 Setting the water hardness on
page 41) or
b) screw in a water filter (see sec-
tion 7.5 Using a water filter on
page 48).
4 Basic operation
4.1 Switching the appliance
on and off
Before switching on after starting up the
appliance for the first time, read sec-
tion 3.4 Switching on the appliance for the
first time on page 35.