MELICONI pratico 6, Инструкция пользователя

Страница: 11 / 64

9
INTERNET UPDATE
Today you can download from the internet directly to your remote control the codes of the latest devices or those
which will be brought out in future, codes which would not otherwise be available using traditional programming
methods. To do this you need to purchase the special MELICONI Audiocable , which allows you to download
the information you need onto any PC using an internet connection. Then go to the www.meliconi.com/guide
website and follow the on-screen instructions.
MEMO FUNCTION
The MEMO function enables you to record a sequence of commands and to recall them by pressing a single
button. Example: switch on the TV, switch on the DVD, play a video, etc. To access this function, consult the
online guide at the www.meliconi.com/guide website
DISPLAY CODE IN USE
If you set up the remote control using the
MANUAL SEARCH
procedure, obtain and make a note of the code in use as follows:
1. Press and hold down for 6 seconds the device selection
button corresponding to the device you wish to enter
the code for. Note: Use the PVR button if the device is a
VCR .
2. Release the button. The indicator light will fl ash. Press
the TV / RADIO button for an instant.
3. After a pause of several seconds, the indicator light
produces four sets of fl ashes, spaced out, corresponding
to the code to be obtained. Count the number of fl ashes.
Each set of fl ashes corresponds to one fi gure in the code.
Ten fl ashes correspond to the fi gure 0.
4. Make a note of the code obtained on the label on the
inside of the battery cover. You may need it in future.
Code obtained = 1306
6 SEC.
or or or or
ENTERING THE CODE DIRECTLY
(only to be performed if you know the speci fi c code to be set)
1. Press and hold down for 6 seconds the device selection
button corresponding to the device you wish to enter
the code for. Note: Use the PVR button if the device is a
VCR .
2. Release the button. The indicator light will fl ash.
Immediately enter the speci fi c code previously found.
(e.g. 1306)
3. Three long fl ashes indicate a correct setting.
If they do not appear, repeat the procedure. If the result is still negative, it means the code indicated
is not included in the remote control. So you need to load it via INTERNET.
(see following section)
6 SEC.
or or or or