The Personal 3 plus remote control is equipped with Learn technology that can acquire and memorise signals from other
infrared remote controls. This feature is particularly useful in several cases.
To add or change a function connected to a button on the MELICONI remote control.
Having activated the remote control and checked it is working correctly, you may need to add or replace a function on one
of the MELICONI remote control buttons with another function you consider to be handier or more frequently used.
Assign some functions to some buttons to control other devices (example: /- SOUNDBAR).
The Personal 3 plus remote control can learn up to a maximum of
10
signals coming from various original remote controls
and connect at will to the desired buttons.
Signals can also be learnt and set on all the buttons on the MELICONI remote control, except the
button. Obviously the
preset functions are lost, but they can be restored by setting again the activation code.
The Learn operation can be repeated numerous times, and the signals captured are kept in the memory even if the batteries
are removed or go flat.
●
POSITIONING THE REMOTE CONTROLS CORRECTLY.
• Check that the batteries in both remote controls (the original and the MELICONI remote) are
fully charged; if semi-charged batteries are used the signal acquisition procedure may prove
difficult or fail completely.
• Position the original remote control in front of the MELICONI remote control so the areas which
emit the infrared signals are opposite each other at a distance of approximately 2 cm.
• On the MELICONI remote control press for a moment the
button.
• Within 30 seconds, press and hold down one of the buttons on the original remote control; the
LED on the MELICONI remote control should start flashing; if it doesn't, move the remote
controls closer together.
• Gradually move the original remote control away, making sure the two remotes stay aligned,
until the point at which the LED stops flashing; then move the remote control to half the previous
distance and keep both remotes in this position until the process has terminated.
●
CAPTURING SIGNALS.
• On the MELICONI remote control press and hold the
button until the LED lights up; release.
• Press the
button again briefly and immediately press for a moment the button to which to combine the capture signal.
• Press the button on the original remote to be captured, hold it down until the LED goes out and then release it.
IMPORTANT: If after releasing the button the LED comes back on, press the same button again until the LED goes out
once more.
• When the signal has been captured correctly the LED will produce three final flashes.
To capture other signals to connect to other buttons, repeat the procedure described above.
Reached the number of records available, the dedicated memory becomes full, preventing further use.
To free memory use one of the following procedures in relation to the data that you want to delete:
• DELETE FUNCTION BY SINGLE BUTTON
• ENTERING THE CODE DIRECTLY
• RESET THE REMOTE CONTROL
web:
e-mail:
IMPORTANT!
To obtain technical assistance, it is essential to indicate the BRAND and MODEL of the appliance you intend
to control and the name of the MELICONI remote control you are using.
ASSISTANCE
LEARN FUNCTION