12
Learning missing functions from an original remote control and saving
them on any button on the Universal 5 web
To acquire signals you must
fi
rst make sure that the remote controls are the correct distance apart:
At this point the maximum data exchange distance between the two remote controls will have been
reached. To acquire signals the remote controls must now be positioned at half this distance and then not
moved any further until the process has terminated.
Important
: when you release the button, if the
LEARN
button light comes on again, press the same button
on the original remote control again until the light goes out once more.
Having programmed the
Universal 5 web
, every time you press a button linked to a
LEARN
command,
both the light corresponding to the device being used and the
LEARN
button light will come on.
1.
Position the original remote control in front of the
universal remote control so that the areas which emit the
infrared signals are opposite each other at a distance of
approximately
5 cm
.
2.
Press the
LEARN
button for an instant and then, within
fi
ve seconds,
press and hold down
any button on the
original remote control. The green light under the
LEARN
button should then start
fl
ashing. If it doesn’t move the
remote controls closer together.
3.
Gradually increase the distance between the two remote
controls, making sure that they stay aligned until the
point at which the green light under the
LEARN
button
stops
fl
ashing.
5 cm
max. dist.
4.
Press the selection button for the required device for an
instant.
5.
Press the
LEARN
button for an instant together with
one of the
F1 - F2 - F3 - F4
buttons or any other normal
button you wish to save the new function on.
6.
The green light on the
LEARN
button will light up in
steady mode to indicate that it is waiting to receive a
signal from the original remote control.
7.
On the original remote control, press the button
corresponding to the signal you wish to capture and hold
it down until the green light on the
LEARN
button goes
out.
or
or
or
8.
If the procedure has been completed successfully the
red light
corresponding to the selected device gives
three long
fl
ashes
. Only at this point will the remote
control be ready to capture other signals to be saved on
other buttons.
or
or
or
or
