+
1
. Switch on the TV.
2
. Look for the brand of your TV in the Code Book and make
a note of the corresponding code indicated alongside (
e.g.
Philips 0025
).
3
. Hold down the
MUTE
and
ON/OFF
keys together for 5
seconds until the light indicator starts to flash indicating
that the remote control is being programmed.
4
. Release the keys and within 12 seconds enter the make
code previously identified (
e.g. 0025
). The light indicator
flashes more quickly to indicate that the remote control
is ready for the search.
5
. Point the remote control at the TV. Press and slowly release
the
ON/OFF
key several times,
stopping
when the TV
goes off.
6
. When the TV goes off, press the
OK
key to confirm.
Three flashes
indicate that the operation has been
completed correctly.
The quickest and easiest way to programme the remote control is
by consulting the website
www.meliconi.com/guide
.
HOW TO PROGRAMME THE REMOTE CONTROL
PHILIPS
0025
F I T T I N G T H E BAT T E R I E S
Before programming and using the remote control,
fit the batteries.
The remote control requires 2 new
AAA/LR03
batteries. Insert the batteries as shown:
• Change the batteries if the light indicator starts to flash
during use. The batteries are low.
• When you remove the batteries, fit the new ones within
5 minutes or you may have to reprogramme your remote
control.
• Make a note of the code for your TV on the adhesive label
inside the battery cover in case you have to reprogramme
your remote control.
To display and make a note of the code memorized by means of the search,
follow the instructions described in the paragraph CURRENT CODE DISPLAY.
ADDITIONAL CHECK
Check that some of the other functions used on your original remote control are working correctly. If the
commands function incorrectly or erratically, you have probably entered a code for a similar remote control
but not the right one. In this case, repeat the search procedure starting from
point 3
, entering the code
previously used (e.g. 0025).
2
5 SEC.
+
+
+
