For any future activation of the remote control, it is advisable to extract and note the code in use, operate as follows:
• On the MELICONI remote control
button until the LED lights up; release.
• Enter the code
0010
.
• After a pause of several seconds, the LED produces four sets of flashes, spaced out,
corresponding to the code to be obtained. Count the number of flashes. Each set of flashes
corresponds to one digit in the code. Ten flashes correspond to the digit
zero “0”.
(
example
code obtained =
1701)
• Make a note of the code obtained. You may need it in future.
●
IF THE REMOTE CONTROL IS NEW AND YOU CAN NOT MAKE IT WORK
It is possible that the code set in the remote control is incorrect for the device that you want to control. Check that you have
carried out all the settings procedures correctly. If necessary repeat them, following all the steps indicated carefully.
Consult the website
to identify the specific code associated with your device or contact the ASSISTANCE.
●
IF THE REMOTE CONTROL IS NO LONGER ABLE TO CONTROL THE DEVICE
Disconnect the device from the electric socket and leave it without power for a few minutes; switch the device on again.
Remove the batteries from the remote control, press the
ON/OFF
button twice and insert NEW batteries.
Make sure that the remote control is pointing at the device without any obstacles between them.
When pressed (even unintentionally) one of the selection buttons, you put the remote control to command a certain type of
device.
Be sure to operate in the mode corresponding to the device to be controlled;
select the correct operating mode
the remote control resumes working.
If necessary try to the RESET OF THE REMOTE CONTROL and carry out a new activation.
●
IF SOME FUNCTIONS ARE NOT AVAILABLE ON THE REMOTE CONTROL
Usually the MELICONI remote control makes available only the present functions on his keyboard, provided they are
available also on the original remote control.
If some of the MAIN functions are not available, you are probably using an incorrect code. Find and set a more suitable code
as described in the ACTIVATION OF REMOTE CONTROL chapter.
Sometimes some functions of the original remote control are not directly present on the MELICONI remote control keypad.
To enable them, operate as described in the BUTTON AND FUNCTIONS chapter.
●
HOW TO CHECK IF THE REMOTE CONTROL SENDS INFRARED SIGNALS
The human eye is not able to detect infrared signals; use a camera (even that of the mobile phone).
Aim the infrared LED located in front of the remote control (not the red LED above) and press and hold on the remote control
the
5
button.
If you see through the camera, the LED light with short white / light blue flashes means that the remote control works and
emits infrared.
ATTENTION!
Most problems are caused by using insufficiently charged batteries.
We recommend checking and replace them as shown in the INSERTING THE BATTERIES
chapter.
TROUBLESHOOTING (F.A.Q.)
DISPLAY CODE IN USE
