To programme the
F A C I L E L i g h t
remote control,
follow the indications in paragraph
A
,
B
or
C
.
1
. Switch on the TV.
2
. Look for the brand of your TV in the code book and make
a note of the code indicated alongside (
e.g. PHILIPS 0025
)
or the code for the brand indicated by the arrow.
3
. Hold down the
MUTE
and
ON/OFF
buttons together for
5 seconds until the light indicator at the top starts to flash
indicating that the remote control is being programmed.
4
. Release the buttons and enter the brand code previously
identified (
e.g. 0025
) within 12 seconds. The light indicator
flashes more quickly to indicate that the remote control
is ready for the search.
5
. Point the remote control at the TV. Press and slowly release
the
ON/OFF
key several times,
stopping
when the TV
goes off.
6
. When the TV goes off, press the
OK
key to confirm.
Three
flashes
indicate that the operation has been completed
correctly.
The quickest and easiest way to programme the remote control
is by consulting the website
www.gumbodylight.com
.
BRAND SEARCH PROGRAMMING MODE
A
PHILIPS
0025
PHONOLA
PHILIPS
+
+
+
F I T T I N G T H E BAT T E R I E S
Before programming and using
the remote control, fit the batteries.
The remote control requires 2 new
AA/LR06
batteries. Insert the batteries as shown:
• Remember to replace the batteries once a year.
• If the light indicator starts to flash while using the remote
control, replace the batteries. The batteries are low.
• When you remove the batteries, fit the new ones within
5 minutes or you may have to reprogramme your remote
control.
• Make a note of the code for your TV on the adhesive label
inside the battery cover in case you have to reprogramme
your remote control.
+
5 SEC.
ADDITIONAL CHECK
Check that some of the other keys, corresponding to those on your original remote control, work correctly.
If the commands function incorrectly or erratically, you have probably entered a code for a similar remote
control but not the right one. In this case, repeat the search procedure starting from
point 3
, entering the
code previously used (e.g. 0025).
8
