(only to be performed if you know the
specific code
to be set)
If you want to use CONTROL 2 Simple to control 2 devices at the same time (TV + DECODER) set firstly
the code for the TV
and then the code for the DECODER. To control just one device, enter only the desired code.
• Press and hold on the MELICONI remote control for at least 6 seconds both
[
P +
]
e
[
+
]
buttons for the TV setting (or
[
P +
]
e
[
P
–
]
for DECODER setting).
• When the indicator light flashes, release and immediately enter the previously identified code.
(
4 digits
)
• Three final flashes indicate that the operation has been completed successfully.
(the service is free, the only cost being that of sending the
SMS
, which depends on your service operator fees)
Send an
SMS
as follows:
2N, Type, Brand, Model
EXAMPLE
ATTENTION
- separate the information with a
comma
and be as
precise as possible
so that the information system can
search for data and answer correctly.
Send the
SMS
to
0039 345 7518893
and wait for a reply by
SMS
.
Once you have received the
SMS
with the list of codes, set the first code (4 digits) in the remote control as described in the
ENTERING THE CODE DIRECTLY
chapter.
After entering the code stand in front of the device already turned on press
ON/OFF
[
]
button on the
MELICONI
remote
control. If the device does
NOT
switch off, set the next code in the
SMS
list on the remote control and try switching the device
off again. Repeat the operation until the device switches off. When the device switches off, check that the other buttons are
also operating correctly. If they do, the remote control is ready to use.
Indicate the
model
of the device to be controlled, usually
shown on a label on the back of the device (if the model
is unknown, do not write anything after the brand)
Indicate the
brand
of the device to be controlled
Indicate the
type of device
to be controller,
using
one
of the following abbreviations only:
TV
TER
(
terrestrial decoder
)
SAT
(
satellite decoder
)
Fixed text which must always be included
SETTING VIA MOBILE (SMS)
If the remote control does NOT carry out the three final flashes, the setting is NOT successful; repeat the procedure.
If still unsuccessful, it means that the code is not included in the remote control, contact the customer service.
ENTERING THE CODE DIRECTLY
2N, TV, PHILIPS,
32PFL3614
