MELICONI Algo 2.1, Руководство пользователя

Страница: 2 / 5

Connect the MELICONI remote control to a Personal Computer (Tablet / Smartphone) with Internet access through the
appropriate audio cable (
NOT included in the package) as shown in figure. Operate as
follows:
• Make sure the remote control is equipped with charged batteries.
• Connect the flat end of the cable to the three-pin connector in the battery compartment.
• Connect the jack of the cable to the audio / headphone output PC (green jack socket).
• On the
www.cme.it website, use the ACTIVATION OF REMOTE CONTROL tool and follow
the instructions.
The functions of the buttons on the MELICONI remote control are only available if the original device is equipped with it.
Sometimes some functions of the original remote control are not directly present on the MELICONI remote control keypad.
To enable them, connect to the
www.cme.it page, use the on-line tool ACTIVATION OF REMOTE CONTROL and continue
until you see the list matching buttons between the original remote control and the MELICONI remote control.
To obtain some functions, press and hold the button and press the corresponding key indicated in the table.
If the function you want to play is matched with an number in orange color, operate as follows:
• On the MELICONI remote control
select the operating mode and then press and hold the button.
• When the LED turn on,
without releasing the button , point the remote control towards the device
and enter the previously identified number corresponding to the function you want to get. (at the last digit
pressure, the remote control already transmits this function)
• Release the buttons; to match the function obtained to a MELICONI remote control button, within 30
seconds, press and hold the desired button.
• Wait three flashes indicate that storage; release the button. (the used button loses the original function
that will be called by setting again the activation code)
For any future activation of the remote control, it is advisable to extract and note the code in use, operate as follows:
• On the MELICONI remote control
select the operating mode and then press and hold the
button until the LED lights up; release.
• Enter the code
0010 .
• After a pause of several seconds, the LED produces four sets of flashes, spaced out,
corresponding to the code to be obtained. Count the number of flashes. Each set of flashes
corresponds to one digit in the code. Ten flashes correspond to the digit zero “0”.
( example code obtained = 1701)
• Make a note of the code obtained. You may need it in future.
If you want to delete the function in combination with a single button, operate as follows:
• On the MELICONI remote control
select the operating mode and then press and hold the button.
• When the LED turn on,
without releasing the button , enter the code 1600 ; release the buttons.
• Within 30 seconds, press and hold the button of which you want to delete the function; wait three flashes indicating the end
of the operation, release the button. (to recall the original function, setting again the activation code)
DELETE FUNCTION BY SINGLE BUTTON
DISPLAY CODE IN USE
BUTTONS AND FUNCTIONS
SETTING VIA AUDIOCABLE
watch
the video
watch
the video