17
Attention: never allow the steam to flow out of the iron whilst it is resting on the stand provided. If the
jet of steam decreases while you are ironing, the boiler tank is running out of water.
Attention: the boiler is always under pressure!
To continue ironing. Top up as follows:
1.Switch off the boiler. Select the desired temperature ”MIN” by turning the thermostat
knobs .
2. Release the pressure left in the boiler, keeping the steam button on the iron pressed
down until no more steam comes out of the plate. Then switch off the iron.
3. Unplug the power cord from the wall socket.
4. Wait for the iron and the boiler to cool down.
5. Unscrew the cap and wait a few minutes.
6. Slowly pour 1.2 litres of water into the opening always using the funnel provided.
7. Close the boiler and fully tighten the cap.
8. Press the boiler switch.
9. Wait for steam pilot lamp to light up before continuing ironing.
CAUTION! Never attempt to open the cap while the boiler is under pressure.
Never unscrew the boiler cap when the appliance is connected
to the outlet.
The iron may smoke slightly when switched on for the first time - this is normal and will soon cease.
If the iron remains unused for a long period of time (a few weeks), we suggest that the steam button be
pressed for about 30 seconds with the iron in horizontal position, as to clean the internal steam
ducts, before you start your ironing session.
It is not necessary to completely fill the boiler tank for short ironing sessions. One measure (or less) of
water is sufficient as to reduce the waiting time and save electric energy.
To iron without steam ,first connect the appliance to the mains supply, press the switch, then
select the desired temperature by turning the thermostat knob.Wait until the pilot lamp goes
off, indicating that the desired temperature has been reached.
For dry ironing it is not necessary to press the steam button.
How to fill the boiler while the appliance is being used
Dry ironing
