MeiTrack T366L, Руководство пользователя

Страница: 6 / 21

MEITRACK T366L User Guide
Copyright © 2020 Meitrack Group All rights reserved. - 6 -
For details, see section 6.5.6 "Setting I/O Port Status – C08."
2.1.6 Auto Arming
You can enable the auto arming function by B27 command, Meitrack Manager software or MS03 tracking platform.
This function is disabled by default.
When the device is in sleep mode and the function has been enabled, the device will enter auto arming state.
You can set disarming by B21 command or remote control.
Function Call GPRS SMS Output 1 Buzzer Description
Open
vehicle
doors in
arming
state
√ √ √ √
When a vehicle door is opened without permission,
the device will dial the authorized phone numbers in
sequence and send a vehicle theft alert by SMS or
GPRS. The buzzer will not stop buzzing until the
arming state is disabled.
Start the
engine in
arming
state
√ √ √ √ √
When the engine is started in arming state, the
vehicle fuel will be cut off, and the device will dial
the authorized phone numbers in sequence and
send a vehicle theft alert by SMS or GPRS. The
buzzer will not stop buzzing until the arming state is
disabled.
Set
arming
while
moving
(Intercept
moving
vehicles)
√ √ √
When the stolen vehicle is moving, you can set
arming by B21 GPRS or SMS command to intercept
the vehicle. When the vehicle speed is lower than 5
km/h and the arming has been set, the vehicle fuel
will be cut off, and the device will send an alert to
the authorized phone numbers.
Note: You cannot use the remote control to set
arming when the vehicle is moving.
Tow
vehicles
in arming
state
√ √ √
When the ACC is off and the vehicle vibrates
continuously, a towing alert will be generated. The
device will dial the authorized phone numbers in
sequence and send a vehicle theft alert by SMS or
GPRS. The buzzer will make sounds for five
consecutive minutes. During this period, you can
disable the arming state and then the buzzer will
stop buzzing.
Note:
1. To implement the fuel/power cut-off function for a vehicle theft alert, you should select the vehicle theft
event in the Output 1 column on the Meitrack Manager software.
2. To implement the alert function of the buzzer, you should set the 1-Wire interface (green cable) to alert
output.