MEITRACK T311 User Guide
Copyright © 2014 Meitrack Group All rights reserved. - 12 -
Disarming
Key
Arming state
Press the key. If the buzzer sounds “beep” twice, the arming state
will be disabled.
Start state
If the vehicle is started by pressing
on the remote control,
press
to stop the vehicle. If the vehicle is started by using
the vehicle key, the Disarming Key does not take effect.
Start Key
ACC OFF
Press the key twice to start the vehicle. If the vehicle is started by
using the remote control in the arming state, the arming state will
be automatically disabled.
Horn Key
Any status
Press and hold down the key for 2s. An SMS/GPRS SOS alarm is
generated.
ACC OFF
Press the key. The buzzer sounds for 4s, and the vehicle owner is
notified of the vehicle location.
5.5.2
RF Remote Control Code Matching Function
If the remote control does not match the tracker, match the code manually. There are the following two code
matching modes:
1.
ACC code matching mode
a)
In disarming state, turn the vehicle key in the lock for 8 times from ACC OFF to ACC ON, and stay on
the ACC ON state. After 3s, the buzzer will sound “bi” 3 times to enter the code matching state.
Note that if it takes more than 3s to turn the key twice, the number of key turning times will
recount.
b)
Press any key on one remote control. If the buzzer sounds 3 times, the code is matched successfully.
Then press any key on the other remote control, the buzzer sounds 3 times. In this way, you can
exit the code matching state. If a same remote control is pressed twice, code matching performed
later for other remote controls does not take effect.
c)
The code matching must be completed within 20s. Otherwise, the code matching state exits
automatically.
d)
When more than one remote controls are implemented code matching, if a same remote control is
pressed twice, code matching performed later for other remote controls does not take effect.
2.
Command code matching mode
a)
Send the SMS/GPRS command
000,B24,1
to enter the code matching state. After the tracker
receives the command, the buzzer will sound 3 times.
b)
If you have two remote controls, press any key on one remote control. If the buzzer sounds "bi" 3
times, the code is matched successfully. Then press any key on the other remote control, the
buzzer sounds 3 times. In this way, you can exit the code matching state.
c)
The code matching must be completed within 20s. Otherwise, the code matching state exits
automatically.
d)
When more than one remote controls are implemented code matching, if a same remote control is
pressed twice, code matching performed later for other remote controls does not take effect.
5.6
GPS Tracking System
Perform the following operations:
