MEITRACK MT90L User Guide
Copyright © 2019 Meitrack Group All rights reserved.
- 13 -
Note:
Phone number: Contains a maximum of 16 bytes. If no phone numbers are set, leave them blank. Phone
numbers are empty by default.
Phone number 1/2/3: SOS phone numbers. When you call the tracker by using these phone numbers, you will
receive SMS notification about the location, geo-fence alert and low power alert.
When you press the SOS button, the MT90L will dial three authorized phone numbers in sequence. It will stop
dialing when one phone number answers, and then will send alert information to the phone numbers.
Note: The phone numbers are blank by default. The phone numbers that are set must be separated by
comma (“,”) to avoid setting failures. No comma is required next to the last phone number. For example:
0000,A71,13500000000,,
0000,A71,13500000000,13600000000,
0000,A71,13500000000,13600000000,13700000000
Reply: 353358017784062,A71,OK
To clear all phone numbers, send 0000,A71.
If this function is unavailable, please add your Country and Area Code before your phone number when you set the
preset phone numbers, or consult your local mobile operator.
7.4
Setting Listen-in Phone Numbers – A72
The command is used to listen in to the surrounding environment. After the setting, the device is allowed to
confidentially and automatically answer a phone and enters listen-in state for one-way communication.
Note: If
Auto Answer Incoming Call
and
Listen-in
are set for a same phone number, only
Auto Answer Incoming
Call
takes effect.
To implement the listen-in function, do not set
Auto Answer Incoming Call
for the phone number, or clear all
phone numbers by sending
0000,A71
.
SMS text:
0000,A72,
Listen-in phone number 1
,
Listen-in phone number 2
Send the text to the embedded SIM card phone number.
The MT90L automatically replies to the SMS: IMEI,A72,OK. It indiates that the listen-in number is set
successfully.
When you call the tracker by using the preset listen-in phone number, the tracker will answer the call
automatically and enter the listen-in state. Meanwhile, the device will not make any noise.
Note:
Phone number: A maximum of two listen-in phone numbers can be set. Each phone number contains at most 16
digits. If only one monitor number is set, the number must be separated by a comma (“,”) to avoid setting failures.
If no phone numbers are set and commas are remained, phone numbers set before will be deleted. The phone
numbers are blank by default.
Example:
Sending: 0000,A72,13844444444,13855555555
Reply: 353358017784062,A72,OK
To clear all monitor numbers, send
0000,A72
.
7.5
Setting the Smart Sleep Mode – A73
This command is used to enable the smart sleep mode, prolonging standby time to 160 hours.
