Operating instructions
ON-OFF
Press the [SELECT] button – the mode will flash.
Using the [+] and [-] buttons switch between modes:
“Cool”………………… Cooling
“Heat”………………… Heating
“Cool” & “Heat”……… Auto mode
“Fan”…………………. Fan only
Note: During demand for cooling or heating, the
active mode will flash.
Press the [SELECT] button again – “Auto Fan” or
“Fan” will flash.
Using the [+] and [-] buttons switch between:
“Fan”…………….…… The fan will work
continuously.
“Auto Fan”…………… The fan will work on
demand for cooling or heating.
Note: Auto fan cannot be selected in Fan only mode.
Press the [ON] button to turn the thermostat ON or OFF.
Modes and Auto fan (fan on demand)
Set point
Press the [+] or [-] buttons once to view the set point temperature.
Press again to adjust the set point.
Cool
Heat
Cool
Heat
Fan
Cool
Heat
Auto
mode
Fan only
Tel: +972-3-9626462
Fax: +972-3-9626620
support@meitavtec
.
com
File: FMT24-SUPER_operating manual.vsd
FMT24-SUPER
Owner’s manual & Technnician Settings
Pg. 2
Auto fan
OFF
Auto fan
ON
Auto Fan
Fan
ON
SELECT
F
Aux
Make sure the set point temperature is different than 10
°
C (50
°
F).
Press and hold the [SELECT] button to activate emergency heat – release the
[Select] button when "EH" appears on display.
Press and hold the [SELECT] button again to deactivate emergency heat –
release [Select] button when “H” appears on display.
Notes:
1. Emergency Heat can be activated in heat pump configuration only (please
refer to the technician settings section in this manual) and in heating mode.
2. When the Emergency Heat is active, the compressor will stop and only the
heat element will be used for heating. The display will alternate between “EH”
and the room temperature.
Emergency heat – to be used in extremely low outdoor temperatures
Emergency
heat
