46
Mixing
substance
volume
maximum 80 litres
Spiral stirrer
type WK
120
Electrical data
Operating
voltage
230 V~
Mains frequency 50 Hz
Power
consumption
1,400 W
Protection class II
Idle speed
0–760 min
-1
Torque
12,5 Nm
Ergonomic data
Sound pressure level
L
pA
= 89 dB(A)
L
WA
= 100 dB(A)
Measuring inaccuracy
K
pA
= 3 dB
K
WA
= 3 dB
Vibrations a
h
= 5.673 m/s
2
Measuring inaccuracy
K = 1.5 m/s
2
a
h
“mixture of hard water”
The measured vibration
values were determined in
accordance with EN 60745.
The specified vibration emission value
was measured in accordance with a
normed test procedure and can be used
in order to compare one electrical tool
with another.
The specified vibration emission value can
also be used for an introductory
evaluation of the influence.
The vibration emission value may fluctuate
from the specified value during use of the
power tool. These fluctuations will depend
on the way in which the tool is used.
Try to keep the vibration loads as low as
possible. Examples of measures that may
be taken to reduce the vibration load
include wearing gloves when using the
tool and limiting the length of the working
period. All parts of the operating cycle
must be taken into account for this
purpose (for example, also including
times in which the power tool is switched
off and times in which it is switched on,
but is running without load).
5 – Using the stirrer
Mounting the stirrer axle and stirrer
Driven moving parts.
Risk of injury if switched on
unintentionally.
Disconnect the device from
the power supply.
Use the correct stirrer type suitable for the
consistency of the substances being
mixed.
Consistency stirrer type
Pasty
WK 120 (included in the
scope of delivery)
Viscous
WK 120 (included in the
scope of delivery)
Thick liquid
(accessory)
Thin liquid
(accessory)
Figure 3: Mount the stirrer axle.
Figure 4: Mount the stirrer.
MW-5451870-Bedien-1612_(54) 27.12.16 14:04 Seite 46
