49
rotation speed continuously to the
respective job.
• Light pressure on the switch (3) = low
rotation speed, in order to loosen
stuck bolts.
• Switch pressed hard = highest
possible rotation speed, for boring.
CAUTION! Avoid the motor coming
to a standstill under loading when
boring or screw-driving!
Clockwise/anti-clockwise run
You determine the rotation direction with
the aid of the slide switch (4) above the
operating switch.
PLEASE NOTE! Change rotation
direction only with motor stopped!
• Screw-driving in bolts: Slide switch to
Position R.
• Turning off bolts: Slide switch to
Position L.
Rotation stop
The rotation spindle is locked in the
centre position of the right/left rotation
switch (4), and thus acts as safety
position when taking a break or
changing a bit or a drill.
In the rotation stop mode, the power
tool cannot be put into operation using
the On/Off switch.
CAUTION! Carry out changeover
with motor stopped only.
Setting the torque
With the torque setting selection
switch (2) you can pre-set the required
torque in 16 + 1 levels. When the
correct setting is selected the power
tool stops as soon as a screw is flush
with the material or when the previously
set torque is reached.
The correct torque will depend on the
material and the screw size and
should be determined by trial runs.
To remove screws, you may select a
higher torque or switch to the "Drill"
icon
. In the "Drill" setting, the
torque setting function is deactivated.
CAUTION! In order to prevent
damage to the battery, the
On/Off switch should not be activated
after an automatic stop of the power
tool. Any protruding screws should be
tightened with a screwdriver.
Magnetic rest (Figure 8)
The power tool has a practical magnetic
rest (11). This can be used to house
screws or bits for a short time.
10 – Maintenance and
environmental
protection
Clean the case only with a damp cloth –
Do not use solvents! Then dry well. To
5451370-Akku-Bohrs-man 30.01.14 07:12 Seite 49
