4.3 Extended Conguration via Telnet
Page 11
4.3 Extended Configuration via Telnet
As soon as the network parameters of the LANPOE Converter module are correctly set, you can start conguring
the unit by using a standard Telnet client. All you need to know is the IP address of the LANPOE Converter
module and the correct access password. The default password is meinberg.
You need to connect to port 9999 of the module, so please start a telnet session with the IP address of the
unit and port 9999.
Please note: Telnet sessions are always unencrypted, even the password is transmitted in plain text.
It is highly recommended to only connect to the module via Telnet in a secure, separated network in order
to avoid a network snier to nd out your password. The safest method is to directly connect a laptop with a
crosslink cable and use this laptop to congure the unit.
The changes made during the Telnet session are activated after you left the setup with Menu Option 9 (Save and
Exit). Only in this case the parameters are stored permanently and the module is restarted.
After you initiated a Telnet connection with the LANPOE Converter, you are presented the Welcome message
and have to enter the access password. If the password has been entered correctly, you have to press enter again
to start the setup tool:
*** NTP Slave Clock V1.00
:Meinberg Funkuhren ***
Hardware : Ethernet TPI
NTP Slave Clock addr
: 172.16.3.234, gateway 172.16.3.1, netmask 255.255.0.0
NTP Time Server IP 1
: 172.16.3.235
NTP Time Server IP 2
: not set
Display delay time [+/-ms]
: 0
NTP client stratum [1-15]
: 10
DCF_Mark output
: aktiv high
Time Zone Daylight on
: Sun after 25.03 at 02:00 UTC +120min
Time Zone Daylight o
: Sun after 25.10 at 03:00 UTC +60min
SNMP community name for read
: public
SNMP community name for write
: public
SNMP manager IP address 1
: not set
SNMP manager IP address 2
: not set
SNMP manager IP address 3
: not set
SYSLOG is disable Server IP
: not set
Change Setup:
0 Server conguration
5 Time Zone conguration
1 Security conguration
6 NTP client conguration
2 SNMP conguration
7 factory defaults
3 SYSLOG conguration 8 exit without save
4 DCF_Mark output
9 save and exit
Your choice ?
NTP-SLAVE-CLOCK
Date: 2nd July 2015
11
Содержание NTP-SLAVE-CLOCK
Страница 2: ......
