Meinberg IMS-GNS181-UC, Руководство по установке

Страница: 13 / 18

4.1.1 Configuration of IMS Modules via Web Interface
This chapter shows how to configure a IMS clock module, for example a GNSS receiver.
4.1.1.1 Clock
On this page of the web interface, configurations can be made on the respective installed reference clocks or
the changeover card.
Depending on the design of the system, which means whether it is a single reference clock or a system with two
installed remote clocks and a changeover card, the web interface builds up accordingly. This also applies to the
type of reference clock and its options. In case of a redundant receiver configuration the common settings for
"IRIG In/Out", "Serial Ports", "Time Zone", "Enable Outputs", "Programmable Pulses" and "Synthesizers" appears
into the "Switch Card" menu.
Figure: Menu "Clock → Status & Configuration → Misc" - selection of the satellite navigation system
A detailed overview of all other settings can be found in the current LANTIME firmware manual: "Web In-
terface
→
Documentation & Support" or on our manual download page:
https://www.meinbergglobal.com/english/docs/
10 Date: 31st January 2020 IMS-GNS181-UC Setup Guide