bale grab Meijer KM 8
– EN
8
5. Installation, starting up, adjustment
Check if the bale grab is undamaged and in good condition on delivery. Please
contact Meijer Holland if you notice any damages. Use the collector only if it is
found to be in good order and after this manual has been read.
5.1 After delivery
Place the bale grab on a solid and even ground.
5.2 Before moving the bales
1. Drive the vehicle in such a way to the bale grab that the mounting surface falls against the
mounting point of the bale grab.
2. Attach the bale grab to the vehicle.
3. Check the couplings for dirt. Attach only clean couplings to prevent dirt from entering the
system.
4. Connect the two correct hydraulic hoses of the vehicle to the two quick release couplings
above the mounting point of the bale grab. The upper hose is for clamping the bales and
the lower one is for releasing them.
5. Check for leakage.
6. Check the correct control of the cylinder from the hydraulic system.
7. Put the hydraulic system under pressure and test the bale grab by opening and closing
the hooks.
5.3 After moving the bales
1. Place the bale grab with the vehicle on a solid and even ground.
2. Check whether the bale grab stands steady.
3. Disconnect the hydraulic hoses and check them for leakage.
4. Dismount the junction of the vehicle from the bale grab and drive away in reverse.
Store the collector in a dry and clean environment.
