Meijer Holland Limo Hydra 15M, Руководство пользователя

Страница: 9 / 22

Bale collector Limo Hydra – EN 9
5. Installation, starting up, adjustment
Check if the bale grab is undamaged and in good condition on delivery. Please contact the supplier
or Meijer Holland if you notice any damages. Only use the bale collector if it is found to be in good
order and after this manual has been read.
Make sure that the baler and the collector stand horizontally.
5.1 Installation
1.
Remove the standard platform that is attached to the baler.
2. Drive the tractor up to the collector so that mounting surface of the baler is as close as
possible to the mounting point of the bale collector.
3. Make sure that the machines stand on an even ground during the installation of the
collector.
4. Mount the supplied platform (photo E) to the Limo Hydra.
5. Mount the platform to the baler with the respective pin (photo F) and the shore strips.
The platform with the shore strips works as a kind of funnel. It assures that the bales fall
gradually on the collector and not too close to each other.
6. See the example for a complete assembly (Photo G, page 9).
7. The strips, the platform and pin must always be secured properly.
8. Connect the supply lines and return lines to the baler. The bale collector is supplied with
the lines until the press channel. A single acting valve with a unpressurised return flow is
required.
9. Check that there is no leakage and that the rollers rotate in the correct way (Photo H,
page 9).
Photo F — pin for platform
Photo E — platform