10
6.1 Connecting the ADL-MXmini
®
The following steps must be taken in order to connect the ADL-MXmini
®
with other devices:
▪
Connect sensor / transducer and ADL-MXmini
®
via cable.
The termination at the end of the respective bus system has to be activated or the
bus has to be terminated with the respective terminating resistance (120 Ohm).
▪
If applicable connect further sensors, emitter, signal devices or large display.
▪
If applicable insert SIM card and connect GSM antenna.
▪
Use the wall plug transformer to connect the ADL-MXmini
®
to power supply.
▪
Connection to a PC gets established via Ethernet cable (crossover cable) or via
integration into a network.
.
After being connected to power supply the boot screen will be shown on the ADL-MXmini
®
and after further 20 seconds the device is ready for use.
