PAGE 5
SB-8180 INSTRUCTION & OPERATION MANUAL
REAR PANEL
REAR PANEL
1
3
RS 232 CONNECTION
RS 232 control port to allow for interfacing to a
PC, Such as a computer or touch panel control,
to the switcher via this DB-9pin Female connector
for serial RS-232 control.
DC POWER INLET
The switcher is fitted with a DC power plug-park
input connector. Please ensure that the plug-park
used is of an approved type and is of sufficient
current carrying capacity with the correct voltage
and connector polarity. 12Volt DC power supply
2A Max.
OUTPUTS - 1~8 VGA-RGBHV PORTS
Remote port :
DB-9pin Female connector
VGA (RGBHV) Via 1x HD-15p connector
Note:
With 1x female D-Sub connector.
Connect a signal of VGA via VGA cable output to VGA
Monitor displays from 8x VGA input source devices.
Power Jack:
DC Jack - inner OD O 2.1mm (+ )
Outside OD O 5.5mm (GND)
Power input - 12VDC, 2A
Switcher power suppler use universal
Part number : TA 007
2
INPUT - 1~8 VGA SOURCE PORTS
4
Connect a signal source of VGA (RGBHV) devise via VGA
cable output to 8x VGA Monitor displays
INPUT 1, 2
INPUT 1, 2
1
1
2
2
VGA
VGA
VGA (RGBHV) Via 1x HD-15p connector
Note:
With 1x female D-Sub connector.
OUTPUT 1, 2
OUTPUT 1, 2
1
1
2
2
VGA
VGA
RoHS/95/EC
INPUT
DC 12V
RS 232
RS 232
INPUT 1, 2
INPUT 1, 2
INPUT 3, 4
INPUT 3, 4
INPUT 5, 6
INPUT 5, 6
INPUT 7, 8
INPUT 7, 8
OUTPUT 1, 2
OUTPUT 1, 2
OUTPUT 5, 6
OUTPUT 5, 6
OUTPUT 3, 4
OUTPUT 3, 4
8x8 VGA MATRIX SWITCHER
VGA RGBHV Signals
OUTPUT 7, 8
OUTPUT 7, 8
1
1
2
2
3
3
4
4
6
6
7
7
8
8
5
5
1
1
2
2
3
3
4
4
6
6
7
7
8
8
5
5
1
3
4
2
CONNECTING THE HARDWARE
Please study the panel drawings below and become familiar with the signal input-output, Power requirements plus
any controls present.
Before using the switcher, please take the time to make certain that the device you wish to connect to its inputs
is functioning properly in all respects. Verify that the video and audio signals are present and are being displayed
properly on a suitable device.
If all is well connect the appropriate cables between the output of the device you wish to distribute to output(s)
of the switcher to the carious devices you wish to feed a signal to. Lastly, connect the AC to DC adaptor,
connect the DC connector to the switcher first and then plug the adaptor into a functional AC outlet.
