Copyright 2007 MEI Page 5 of 6
Installation Guide & Specifications 20105-00289XXXX-IG G1
Ensure that computer is fully powered off when first installing this equipment. If
the equipment is not powered off, do so now.
Route the cable attached to the reader base to the rear of the personal computer
such that you can attach the opposite end of the cable to the USB port on the
personal computer.
Note: If you are using more than one reader base, each base must be installed to
a separate USB connector.
Attach the cable as shown below to the personal computer such that the USB
connector is fully attached and latched if appropriate.
Note: The next generation of the EASITRAX SC READER base will be
compatible with USB connections and will not require keyboard connector pass
through to power the device.
Once the reader base cable is fully installed, you may power on the personal
computer and allow the computer to boot up.
The blue front panel LED on the Easitrax SC Reader base should light and go
through a brief power on test. Following this test only the blue power on indicator
LED should be illuminated.
The Easitrax SC Reader base is now ready for use with the back room
accounting software loaded on your PC by your currency sorter/counter vendor.
That software should allow you to read full cassettes and record identifying
information prior to removal of the cashbox from the reader base.
You may wish to test the system functionality by placing an unread cashbox
cassette onto the base following the instructions imprinted on the reader base.
Ensure that the cashbox handle is facing the front of the base and that the top
side of the cashbox cassette is placed nearest to the reader base. Using the
software, you may select from several different functions to verify that the reader
base will read both full and empty cashboxes.
Once you have verified the performance of the system, you are ready to begin
using your reader base in normal operation.
