Installation
The Series CV1000 has been designed for
ease of mounting onto existing studs provided
by Original Equipment Manufacturers (OEMs).
Some machines may require brackets or
faceplates to mount the unit. Refer to your
machine operation manual or contact your
distributor/OEM for more model-specific
mounting information.
1. Disconnect all power to the machine.
2. Secure the unit to the mounting studs
with the appropriate hardware.
3. Connect the interface harnesses from the
machine to the unit.
4 -
11/32 nuts
4. Apply power to the machine.
5. Check the Status LED for the “Steady
ON” condition. If the LED is flashing,
refer to the Status LED Chart.
6. Insert a bill to check acceptance. If
enabled, the bill will be accepted.
7. Make a vend to ensure credit is received
and proper change is paid out for the
bill.
The Series CV1000 is preconfigured during
manufacture to accept U.S. 1.00’s. The
Series CV1000 can be manually configured
using an option coupon or by inserting a bill
of the desired denomination . If the Series
CV1000 is reprogrammed using a coupon
with a different configuration, the new
configuration will be the default. The coupon
configuration will remain in memory even with
the power off.
COUPON CONFIGURATION
PROCEDURE
1) Carefully copy the coupon from the Installation
Guide. Make copies of the coupon with a
standard, carbon-based, non-color copier.
The copies of the coupon must be the size of a
U.S. $1 dollar bill.
2) Use a #2 pencil to fill in the blocks for desired
options.
For correct operation, all 3 sections must be
completed. Fill in only one block per line.
Do
not mark anywhere else or on the back of the
coupon.
Complete section 1
to enable desired
bill denominations. Enable 1 or 2 direction
face up, or 4 way acceptance (which allows
acceptance in all directions).
Complete section 2
to enable desired
bill denominations. Fill in one block for
each denomination. Be sure to mark all the
denominations.
Off
will reject bills of the selected denomination.
ACCEPT
will accept bills of the selected
denomination.
Section 3 -
Not Applicable
Section 4
- Not Applicable
Complete section 5
to control the Bezel
Lights
.
Flashing or constantly ON may
be selected.
3) Locate the blue configuration button on the
back of the unit. Depress the button once to
enter programming mode. The red LED Status
light will flash rapidly. Depressing the button
again will exit the mode.
4) Insert the coupon face up and verify the
settings were accepted.
ACCEPTED:
Coupon returned imediately and
the LED and the green arrows on the front of
the bill validator flash
10
times when coupon is
pulled out.
REJECTED:
Coupon returned after ten
seconds. The red LED and the green arrows on
the front of the bill validator
flash the
number of
times
corresponding to the section improperly
filled out. Example: two flashes for improper
section two.
Bill Configuration
An alternative to using the programming coupon
is to program a CV1000 with a particular
denomination of currency:
Press the Blue configuration Button on the back
of the CV1000 Validator. The red LED status
light, next to the blue configuration button, will
switch from steady ON to RAPIDLY FLASHING.
Insert a bill of the denomination you wish to
enable or disable. The bill will be returned to you.
If it is enabled, the red LED status light and the
green arrows on the front of the bill validator will
flash
10
times.
If the bill is already enabled, it will be disabled, it
will be returned to you, and the red LED status
light and the green arrows will flash
3
times.
Repeat the process to return to the former setting.
7
Flashes means the programming was
not
accepted.
IMPORTANT!!
DO NOT leave the machine until the
Status LED returns to steady ON.
