Megger EVCA210, Руководство пользователя

Страница: 8 / 20

4. General operating instructions
1. EV test cable connector
2. CP Error “E” button
3. PE Error (Earth fault) button
4. PE Pre-Test touch pad and PE Pre-Test warning
LED
5. PP State rotary selector switch
6. CP Signal output terminals (4 mm)
7. Measuring terminals PE, N, L1, L2, L3
(4 mm)
8. Phase indicator LEDs for L1, L2, L3 terminals
9. CP State rotary selector switch
10. Mains plug socket* (Test purposes only /
Maximum 10 A)
*EVCA210-UK Front mains socket =
UK 13A socket
*EVCA210 Front mains socket =
Schuko socket (CEE 7/3)
*EVCA210-CH Front mains socket =
Type J (SEV 1011)
The EVCA210 is designed to test the function and safety of charging points mode 3 for AC
charging. This adaptor allows you to conduct tests using appropriate test instruments such as
appropriate Megger MFT Multifunction testers. With this adaptor, charging points can be tested in
accordance with IEC/EN 61851-1 and IEC/HD 60364-7-722.
Before carrying out testing with this adaptor, the operator should be familiar with all relevant
standards associated with the tests being undertaken.
The Megger EVCA210 test adaptor is designed to simulate the connection of an electrical vehicle
to the charging point under test.
Connection of the EVCA210 adaptor to a charging point triggers the charging process in the
charging point with the Control Pilot (CP) switch on the adaptor selecting the appropriate charging
mode.
The following charging capabilities can be simulated: N/C (No Connection), 13 A, 20 A, 32 A and
63 A, as well as all the possible electrical vehicle modes A, B, C (un-vented) and D (vented), via the
selection switches.
www.megger.com EVCA210
8
General operating instructions