Wood-pellet burner
Nani 35
11.
First use – adjusting the burner's fire
1.
Ensure that the installation has been done according to this manual
2.
Ensure that the plastic pipe
is not
connected to burner's feeding pipe
3.
Fill the feeder up with wood-pellet, by following the direction of paragraph 16
(
Feeder's Filling Procedure
). The filling of the feeder lasts 8-15min depended on
feeders incline.
4.
Ensure that the feeder is full of pellet. Let the feeder working after the first pellets
come out of the feeder for 10-15 minutes (locate a plastic bag at the exit of the
feeder)
5.
Empty the plastic bag and place it back at the exit of the feeder.
6.
Make the feeder work again for 2 minutes, by pressing the button
7.
Weight the wood pellet which is in the bag (for example 0.4kg)
8.
Multiply it by 30 minutes (0.4x30 = 12kg/hr). This is the
feeder's performance
9.
Repeat the steps 4-8
, 2-3 times until you make sure that you weight the right
quantity.
10. Place this value (i.e 12kg/hr) on manufacturer's settings menu, in the
parameter “5. Feeder Performance”
11.
“CHOICE FUNCTION-/+” is written on the screen.
12.
By pressing the button “MODE/ “ once, starts the automatic operation of the
burner
13.
When the maximum power of the burner is reached (from 10 to 35kW), then adjust
the burners flame by calibrating the air.
The burning air is calibrated just by changing the value of “Overflow pellet's
air” at Manufacturer's menu. The value must be between 0.20-0.7,
depending on the maximum burner's power, pellet quality, boilers
construction and chimney's draught.
12.
Start of the burner
1. Activate the burner by connecting it with a power supply (230Volt, 50Hz)
2. It is written on the LCD screen the following
3. By pressing the button “
MODE
/ “ once changes the operation from “
Stop
” to
18
CH:---- C WUW:---- C
STOP
