6
Installing
Antenna & Batteries
of the transmitter. Slide it into the hole
on top of the transmitter and turn clock
wise until snug. Do not over-tighten.
“off” position.
B. Install 8 fresh “AA” alkaline dry
cell batteries in the transmitter
(see
Figure 5
) paying careful
attention to proper “+” and “-”
polarity. Turn the transmitter on to
make sure the LED light glows
green. Fresh batteries will provide
2 hours of power to the
transmitter. When the red LED
light glows, immediately install
Installing the Antenna
Installing the Batteries
Figure 5 - Transmitter Batteries
fresh batteries. Failure to do so will result
in loss of control and (most likely) a crash.
Figure 6
).
D. Turn on the transmitter power switch, located
inside the door on the back of the transmitter
(see
Figure 7
). Next turn on the vehicle’s power
switch and listen for the servos to move slightly.
Move the steering control wheel and the throttle
trigger on the transmitter, making sure that the
steering control operates the front wheels and
Figure 4 - Install Antenna
Figure 6 - Vehicle Batteries
Figure 7 - Power Switch
