4
Setting Up the PICO Projector
1.
Plug the Power Adaptor to the DC in connector at the rear of the DLP Pico
Projector.
Note : For first time use with internal battery, charge unit for about 4~5hours
2.
Slide the ON/OFF power switch towards the rear of the unit and hold until
the display turns on, “Booting Up----“. The Projector will take a short while
to initialize. After booting up, the projector will display the Home Screen
3.
Place the Projector at a suitable distance so the image size is around 30” to
80” diagonal
4.
Turn the Focus Knob to bring the image into focus.
5.
Navigate the Mouse Cursor with the built-in Capacitive Mouse Touch Pad to
operate the projector. Alternatively, connect a wired/wireless mouse to the
USB A connector.
6.
External signal source can also be played through the projector via the
HDMI, AV and VGA input connectors.
Caution:
Always use the power adaptor that was shipped with the Pico Projector. The adaptor accepts power
90-264V 50-60 Hz. Check to ensure that the main voltage is within the range on the rating plate on the rear of the
projector. When disconnecting the Pico Projector, always power off the unit before attempting to remove the AC plug
from the power source.
