23
Advanced
The following introduces the camera
’s Web Server port, RTSP port, MJPEG
over HTTP port, and HTTPS port.
Web Server port
The default web server port is 80. With the default web server port
‘80’,
users can simply input the IP address of the camera in the URL bar of a
web browser to connect the camera. When the web server port is
changed to any number other than 80, users have to enter the camera
’s
IP address followed by a colon and the port number. For instance, a
camera whose IP address as 192.168.0.100 and web server port as
8080 can be connected by entering
“
http://192.168.0.100:8080
” in the
URL bar.
RTSP port
The default setting of RTSP Port is 554; the RTSP Port should be set as
554 or from the range 1024 to 65535.
MJPEG over HTTP port
The default setting of MJPEG over HTTP Port is 8008; the MJPEG over
HTTP Port should be set as 8008 or from the range1024 to 65535.
HTTPS port
The default setting of HTTPS Port is 443; the HTTPS Port should be set
as 443 or from the range 1024 to 65535.
NOTE:
Please make sure the port numbers set above are not the same
with each other; otherwise, network conflict may occur.
Link Mode (Full HD Ultra-WDR Speed Dome Fiber IP Camera Only)
Users are able to setup the network data transmission speed here.
Choose
“Auto”, and the camera will auto detect the network environment
to decide the suitable data transmission speed. Choose
“100Mbps/Full”,
and users can manually set the data transmission speed at 100Mbps in
full-duplex mode. Click on <Save> button to complete the setting.
Note that if users are to use SFP port for data transmission, users
MUST
shut down the camera first to activate the saved setting. When users
use RJ45 / SFP port for data transmission and use Auto mode or
manually set the data transmission speed at 100Mbps, be sure that the
data transmission speed of the switch is set at the same.
