16
Notice: Please keep the cold film tension and flat.
4.
(
For hot films
) Drag some hot film out through the rollers, then fix the film on the
finished products roll (Just for beginner). Or the machine slowly running at the
beginning, someone darg the film at the back of the machine. He can tie the finished
products on the finished products roll.
5.
Fix the printings and darg it onto the steel work table. Put the printings in the middle
of the rollers.
Notice: The sides of the printings and the rollers should be vertical.
6.
Lift the upper roller down and anticlockwise turn the hand wheel to impending state.
Press "continue" button to start laminating.
Notice: If the film is not had the proper tension, please clockwise turn the damping grip to increase the
fraction.
Clockwise turn the speed button to a proper speed.
Notice: The more faster speed the more heat dissipation, so please choose the proper speed and
temperature of laminating.
If there have folds of the finished products, please cut away and restart the
lamination.
6.3 Notices
1.
The finished products should tie around the finished products roll.
2.
The printings should tie around the paper tube and fix on the feeding roll, then the
printings should snap to the films.
3.
The printings should tighten tie around the paper tube. In order not to go tilt the
sides of the printings and the rollers should be vertical.
4.
If the printings still go tilt under the right procedure, you should press the winkled
printing to increase the fraction slowly.
5.
Please keep the proper fraction of feeding roll, film roll, finished products roll to
ensure the quality of laminating.
