18
ENGLI SH
SAFETY INSTRUCTIONS
Read the Operating Instructions carefully before use!
•
Read these Operating Instructions carefully before using the machine.
•
Do not allow children to play with or use the machine.
•
The machine must only be used to cut wood.
•
Unauthorised persons are not allowed in the work area.
•
The user is responsible for ensuring that the instructions are followed.
•
Children and animals must be kept away from the machine during use.
•
The work area must always be well lit when using the machine.
•
Keep the work area clean.
•
Always wear ear protection when the machine is used.
•
Wear eye protection when working with the machine.
•
Remove all rings, bracelets and other jewellery when using the machine.
•
The machine must be connected to an extractor.
•
Make sure the hoods and connections to the extractor are intact and tight.
•
The machine must not be lifted by the worktables.
•
Roll up your sleeves to your elbows.
•
Fasten or remove all loose-fitting clothing when using the machine.
•
Never wear gloves while working.
•
Always use the correct tool for the job.
•
Replace damaged labels on the machine.
•
Check that the start control is in the stop position before connecting the machine to the mains.
•
Focus all your attention on the work when using the machine.
•
Keep unauthorised persons away from the work area when working with the machine.
•
Carefully check that all tools are removed before starting the machine.
•
Do not touch rotating parts or tools with any body part or tool.
•
Never force the work process.
•
Wear a hair net if you have long hair.
•
Check that all parts are properly tightened and intact before use.
•
The saw blade must always be sharp.
•
The motor must be stopped and the power cord disconnected before performing the following:
-
Removing safety devices.
-
Maintenance or cleaning.
-
Changing the blade.
-
When the machine is left unattended.
•
Do not pull the power cord to disconnect the plug.
•
The machine must not be changed or modified.
•
All the safety devices must be in place and function when the machine is being used.
•
Always be careful when starting the machine.
•
Check that all screws and nuts are tightened.
•
Use only original spare parts. Spare parts must not be repaired.
•
The machine must not be used in explosive environments.
•
Do not use the machine near flammable liquids or gases.
•
The machine must be plugged into an earthed socket.
•
The electrical system must be equipped with a residual current device.
•
Keep the work area clean.
•
Always make sure that no spanner or other tool is left on the machine before turning it on.
•
Use the supplied pusher when working close to the saw blade.
•
Do not expose to damp conditions.
•
The machine must not be exposed to water.
•
The power cord must only be replaced by the supplier.
•
Repair work must be carried out by the supplier.
•
Make sure the upper guard always has the correct setting.
•
Only use saw blades that meet the EN 847-1 standard.