Meec tools 154-084, Руководство по эксплуатации

Страница: 22 / 24

ENGLISH
22
USE
Applications
The tool is intended for stapling cardboard, insulation materials, fabrics, plastic foil, leather and other similar
materials on wooden surfaces, etc.
Charging the battery
New batteries and batteries that have not been used for a long time only reach full capacity after they have
been charged and discharged about 5 times.
Do not charge the batteries after use if you know that they will not be used for a long time. Charge the batteries
before using them.
1.
Remove the battery from the staple gun by
pressing the battery lock buttons and pulling the
battery out backwards. Do not force.
2. Insert the battery in the charger.
3. Connect the power to the charger.
If the battery quickly goes
fl at after recharging, this
means that it needs to be replaced.
Used batteries must be disposed of in accordance
with local regulations.
Re fi lling the magazine
NOTE: Remove the battery before working on the tool. Only use original accessories. Always use the correct
type of staples and nails specially intended for the magazine and fi ring mechanism etc.
1. Press and hold down the locking lever.
2. Pull out the magazine.
3.
Insert the staples or nail strip. Tilt the stapler
slightly when inserting the nail strip, so that the
nails press against the side wall.
4. Press the magazine fi rmly against the stapling
head and press the locking lever to lock the
magazine.
Before using for the fi rst time
Insert the charged battery in the handle. Make sure that it locks properly in place.
Starting/stopping
1. Press the stapling head with a slight pressure against the workpiece.
2.
Press the trigger quickly, and release. The trigger lock prevents unintentional fi ring if you should accidently
press the trigger.
NOTE: To prevent unnecessary wear, do not fi re the stapler with an empty magazine.
Selecting the stapling force
You select the force with which the staples/nails leave the gun with the control knob.
The force required depends on the length of the staples/nails and the material to be fastened. Find the best
setting by trial and error. Turn the knob to the lowest setting after
fi nishing work to relieve the tension spring.