Meec tools 071-016, Руководство по установке

Страница: 20 / 23

ENGLISH
20
2. Pull back the feeder until it latches (fig. 2).
3. Hold a strip of nails with the pointed ends down (fig. 3) and put it into the magazine.
4. Slide the nails forward in the magazine. The magazine holds 60 nails.
5. Pull the feeder backwards slowly. Press the lock so that the feeder is released and can be slid
towards the nails (fig. 4).
6. Adjust the directional exhaust deflector (A) (fig. 5) so that the exhaust air is directed away from the
operator. Hold the deflector and rotate it to a suitable position.
Using the tool
Complete all steps in the section PREPARING THE TOOL BEFORE DRIVING before you use the tool.
The tool can be fired in two ways.
Place the drive guide on the work surface, gently press the tool against the surface until the safety
bracket is depressed and then squeeze the trigger. This method is effective if you have a comfortable
working position. If you use this method without having a steady hold of the tool, the recoil may cause the
safety bracket to be pressed in again, whereby the tool will drive another nail or drive a nail and then fire
without a nail.
You can also squeeze the trigger and then press the safety mechanism several times to allow the drive
mechanism to drive out the nail. You may find this method easier if you are working in a position that
makes it difficult to empty the magazine.
IMPORTANT!

Take your finger off the trigger when not driving nails.

Never carry the tool with your finger on the trigger as the tool will fire a nail if the safety mechanism
is pressed.
Fig. 5
Fig. 6
Fig. 1 Fig. 2
Fig. 3 Fig. 4