Meec tools 021727, Руководство по эксплуатации

Страница: 34 / 62

EN
34
USE
WARNING!
Switch off the tool and pull out the plug
before adjusting, replacing accessories,
cleaning or maintenance.
CHOOSING SANDING BELTS
Extra sanding belts and belts with different
grades (coarse, medium and fine) can be
bought from Jula’s department stores and
at www.jula.com. Use coarse sanding belts
for rough work, medium belts to smooth the
workpiece, and fine sanding belts to finish off.
Try them out on a spare piece to see which
grade is suitable for the job.
FITTING AND REPLACING SANDING
BELT
1. Select a suitable grade of sanding belt.
2. Pull up the lever that tensions the sanding
belt.
FIG. 2
3. Put on a sanding belt with the arrow on
the inside of the belt pointing the same
way as the direction of rotation on the
tool.
4. Fold down the lever.
FIG. 3
NOTE:
• Do not use worn, damaged or clogged
sanding belts.
• Do not use the same sanding belt for
metal and wood. Metal particles
embedded in the sanding belt will
damage the surface of the wood.
ADJUSTING THE SANDING BELT
1. Tension the sanding belt. Plug in the
power cord and start the tool briefly.
The belt rotates for a short while.
FIG. 4
FIG. 5
2. While the belt is moving, turn the
adjusting knob so that the belt runs in
the middle of the roller.
FIG. 6
3. Press the power switch and turn the
adjusting knob until the belt is properly
adjusted.
4. Run the tool for one minute to check that
the adjustment is correct before sanding.
DUST COLLECTION
Always use a dust extractor if possible. Push the
dust bag onto the dust extraction port.
FIG. 7
STARTING/STOPPING
Push the power switch to start the tool and
release the power switch to switch off.
Continuous operation
Activate
Press the lock button when the power switch is
pressed.
FIG. 8
Deactivate
To switch off the tool, press the power switch
and then release it.
FIG. 9
NOTE:
• Always lift the tool off the workpiece
before starting/stopping the tool.
• It can pull away on first contact with the
workpiece.
SANDING
NOTE: