Meec tools 018279, Руководство по эксплуатации

Страница: 57 / 112

EN
53
• Keep the ventilation openings free from
dust and dirt.
IMPORTANT:
Do not use water or liquid detergent.
REPLACING THE TRIMMER LINE
1. Remove the battery.
2. Remove the line spool from the trimmer
head. Remove any remaining trimmer
line from the spool.
3. Cut about four metres of trimmer line.
FIG. 22
4. Put the trimmer line in the anchor hole
on the top of the spool. Make sure there is
about two metres of wire both ways.
FIG. 23
5. Wind the trimmer line clockwise round
the top of the spool (see arrows on
spool). Put the trimmer line in the slot on
the top flange of the spool, so that about
15 cm of trimmer line sticks out from the
slot. Do not wind on too much – when the
trimmer line is wound on there should be
at least 6 mm of free space between the
trimmer line and the outer edge of the
spool.
6. Replace the spool and spool casing as per
the instructions above.
FIG. 24
STORAGE
• Remove the battery from the product
before putting into storage.
• Remove all foreign material from the
product.
• Keep this product out of the reach of
children.
• Store the product away from corrosive
substances, such as salt.
• Charge and store batteries in a cool area.
Temperatures over or below normal room
temperature reduce battery life.
• Do not store discharged batteries.
Allow the battery to cool and then
charge it.
• Store the battery in a dry place at no more
than 27°C.
• Batteries self-discharge, especially in high
ambient temperature. For best battery
life, charge the battery every or every
other month, even when the product is
not in use.