Meec tools 014168, Руководство по эксплуатации

Страница: 33 / 120

EN
32
TROUBLESHOOTING
Problem Cause Action
No material comes
out through the
nozzle.
The nozzle is blocked.
The suction hose is blocked.
The flow of material is set too low.
The suction hose has come loose.
The pressure in the container is too
low.
The material is too thick.
Clean.
Clean.
Increase the flow of material (+).
Fix the hose in place.
Screw the container on properly.
Thin the material.
Material drips from
the nozzle.
The nozzle is loose.
The nozzle is worn.
Material has accumulated in the air
nozzle, nozzle or paint needle.
Tighten.
Replace nozzle.
Clean.
The material is not
shredded properly.
The material is too thick.
The flow of material is set too high.
The nozzle is blocked.
The air filter is very dirty.
The pressure in the container is too
low.
Thin the material.
Reduce the flow of material (-).
Clean.
Replace.
Screw the container on properly.