Meec tools 011485, Руководство пользователя

Страница: 54 / 59

EN
54
2. Put the pressure relief valve lever (6) in its
horizontal position.
3. Hold the hose in a firm grip and point the
end down into the material container.
Put the switch (1) in the on position.
4. If no material flows out through the hose,
connect the hose again and continue with
step 6.
5. If material flows out through the hose,
follow the instructions for cleaning the
spray gun and filter.
6. Connect the hose to the spray gun and
follow the instructions for preparations
before spraying.
MAINTENANCE
Follow the maintenance instructions for best
functionality and useful life.
• Check and clean the inlet filter and spray
gun filter before use.
• Replace the filters if they are damaged or
if they cannot be cleaned.
• Check the product for leakage, especially
at the connections. Replace any damaged
parts.
• Always check the high-pressure hose for
damage before use. Damaged hoses and
connections must be replaced – never
attempt to repair them.
• Clean nozzle inserts with a brush and a
suitable cleaner fluid after use.
• Nozzle inserts may need to be replaced
after 57 to 277 litres of material has been
sprayed, depending on the abrasive
properties of the material.
CLEANING
1. Carry out steps 1 to 3 in the instructions
for pressure relief.
2. Turn the nozzle insert to the cleaning
position. Press the spray gun firmly
Spray pattern and quality
The material is spread smoothly over the
surface when the spray pattern is correct.
• The material should be finely dispersed
and uniformly applied, without gaps at
the edges.
• Adjust the pressure control knob (8) until
the spray pattern is uniform, without gaps
or thicker layers at the edges.
• If it is not possible to adjust the spray
pattern, check if the nozzle insert is worn,
or try with a smaller nozzle insert (see
table for choice of nozzle insert).
• The material may need to be diluted.
Follow the instructions of the material
manufacturer for dilution.
CLEANING THE NOZZLE INSERT
If the nozzle insert gets blocked during the
spraying, turn the nozzle insert to quickly
and easily clear away the particles without
dismantling the product.
1. Apply the trigger lock and turn the nozzle
insert to the cleaning position. Check that
the nozzle insert is inserted all the way in
the nozzle guard.
2. Release the trigger lock, point the spray
gun down in the container and press the
trigger for 2 seconds.
3. Apply the trigger lock, turn back the nozzle
insert to the spraying position, release the
trigger lock and continue spraying.
CLEARING A BLOCKAGE
Follow the instructions below if no material
comes out through the spray gun, or if you are
not certain that the pressure was fully relieved
when the process for relieving the pressure was
carried out.
1. Release the high-pressure hose very slowly
from the spray gun.