Meec tools 010989, Руководство по эксплуатации

Страница: 12 / 12

EN
12
MEASURING
Start the moisture meter and firmly press
the measuring tips on the material to be
measured, so that the tips are pressed into the
material. The moisture content of the material
is shown in the display.
LOW BATTERY LEVEL INDICATOR
A warning symbol for weak battery starts to
flash when the battery is almost flat.
MAINTENANCE
The moisture meter requires little
maintenance. Follow the instructions below to
keep it in good condition.
• Handle the moisture meter with care and
do not expose it to knocks, dust, liquid,
continuous vibration or extreme
temperatures.
• Check the batteries at regular intervals.
Remove the batteries from the moisture
meter if it is not going to be used for
some time.
• Store the moisture meter in the case
when not in use.
SELECTION OF UNIT
Press the lock button for 3 seconds to switch
between showing the temperature in °F and
°C.
SELECTION OF DETECTION MODE
Step to the required detection mode with the
selector button.
Mode Material Measuring
range
1
Beech, spruce, larch,
birch, cherry, walnut,
oak, pine, maple,
ash, Douglas fir
6 to 44%
2
Cement floor,
concrete, plaster
1.4 to 7.4%
3 Anhydrite floor 0.0 to 4.1%
4 Cement mortar 0.8 to 5.1%
5 Lime mortar 0.4 to 3.7%
6 Brick 0.0 to 8.5%
NOTE:
“0” or “LO” is shown if the reading is less
than the lower limit of the measurement
range, and “HI” is shown if the reading is
over the upper limit.
LOCKING OF READING
Press the lock button to “freeze” the reading
in the display. Press once again to clear the
display.
CALIBRATION
The product must be calibrated if the display
does not show "0" when the product is started
with the power switch.. Press the reset button
in the battery compartment to calibrate.