Meec tools 009874, Руководство по эксплуатации

Страница: 38 / 42

EN
38
7. Connect the other end of the high-
pressure hose to the water outlet and lock
by twisting the black end piece as shown
in the diagram.
FIG. 8
8. Connect the water hose adapter (female
connection) to the water inlet on the
high-pressure washer and connect the
water hose (male connection) to the
water hose adapter.
FIG. 9
USE
Place the high-pressure washer on a level,
stable surface. Plug in the plug.
WATER SUPPLY
NOTE:
Impurities in the water can damage the high-
pressure pump and accessories.
Water supply from open source
The high-pressure washer can be used with a
suction hose with a check valve to take water
from a barrel, or pond.
1. Fill the suction hose with water.
2. Connect the suction hose to the water
inlet on the high-pressure washer and put
the other end in the water (e.g. rainwater
barrel).
3. Vent the high-pressure washer as follows
before use.
4. Start the high-pressure washer with the
power switch.
5. Unlock the spray gun catch.
6. Press the trigger. The high-pressure
washer starts working.
7. Allow the high-pressure washer to run
DESCRIPTION
1. Handle
2. Spray gun holder
3. Cord holder
4. Power switch
5. Power cord
6. Water outlet
7. High-pressure hose
8. Hook for high-pressure hose
9. Spray gun
10. Spray head holder
11. Spray head
12. Spray head II
13. Water inlet
14. Wheel
FIG. 1
ASSEMBLY
1. Put the handle in place and screw tight.
FIG. 2
2. Press the spray gun holder in place on the
right side.
FIG. 3
3. Press the cord holder in place on the left
side.
FIG. 4
4. Fit the spray head holder with the screws.
FIG. 5
5. Fit the spray head in the spray gun and
twist to lock in place.
FIG. 6
6. Connect the high-pressure hose coupling
to the spray gun and lock by tightening
the nut.
FIG. 7