Meec tools 008554, Руководство по эксплуатации

Страница: 32 / 38

EN
32
• Do not move or transport the product
when the air tank is pressurised
• Do not disconnect any air hoses when the
air tank is pressurised.
• Do not attempt to tamper with or modify
the air tank or any another parts on the
product.
• Never point the outlet on the air hose or
any tools connected to the hose at people
or animals.
• Never attempt to blow clean clothes with
compressed air when they are being
worn.
• Never poke your fingers or other any
objects in the casings on the product.
• The product must only be connected to a
230 V 50/60 Hz earthed power point that
has a residual current device with a
maximum tripping current of 30 mA.
• Always connect the plug to an easily
accessible power point so that it can
quickly be pulled out in the event of a
fault.
• Parts of the product get hot when in use.
Only touch the handle and the power
switch when the product is in use.
• Place the product on an easily accessible,
stable and dry horizontal surface. Do not
place the product near the edge of a table
or bench.
• Make sure there is adequate ventilation
for the product. Keep the product at least
1 m away from adjacent walls or any other
surface.
• Position the product so that it cannot
move when in use.
• The product must not stand on its own
feet when in use.
• Never put the product on, or near hot
surfaces.
• The product is not intended to be used by
persons (children or adults) with any form
of functional disorders, or by persons who
do not have sufficient experience or
knowledge on how to use it, unless they
• Do not use accessories other than those
specified in these instructions or
recommended by the manufacturer or
retailer – risk of personal injury.
• Repairs should be carried out by qualified
personnel.
• The product complies with the applicable
safety regulations. Repairs may only be
carried out by qualified personnel using
identical spare parts. Serious personal
injury can otherwise occur.
• Risk of hearing impairment. Wear ear
protection when using the compressor.
• Risk of explosion. Never use the product
where flammable material, liquid or gas
(petrol, solvent, gas cylinders etc.) are
stored or used.
• Never switch off the product by pulling out
the plug. Always use the ON/OFF power
switch or button.
• Always pull out the plug and relieve the
pressure in the air tank before moving the
product, and before service or repairs.
• Keep the power cord away from heat, oil
and sharp edges.
• Do not carry or pull the product by the
power cord or the air hoses. The product
must only be carried with the handle.
• Check that all the air hoses and air tools
to be connected to the compressor are
approved for the air pressure produced by
the compressor, and that they are
correctly connected.
• The product is intended to be used in a
well ventilated area and ambient
temperature of 5 to 40°C.
• Do not expose the product to water or any
other liquid.
• Do not use the product if the air tank is in
any way damaged.
• Check that all the air hoses are
undamaged and approved for the
pressure produced by the compressor.
• Damaged air hoses must be replaced –
never attempt to repair a damaged air hose.