Medrad Mark 7 Arterion, Руководство по эксплуатации

Страница: 67 / 162

Preparing for Injection
10 - 59
NOTE:
With 15 mL Purge turned ON or OFF , the system will require a purge in the upright
position during system power-up, syringe installation, and new case.
10.8 Defining a Protocol
Recall a protocol from the Protocols tab or set a protocol from the Home tab. For more information,
see "Chapter 9 - Setting and Managing Protocols" .
The Injector is ready to be armed. For more information, refer to "Chapter 11 - Arming and Injecting" .
10.9 Turning ISI On or Off
NOTE:
To use ISI, ISI must be enabled from the Options tab and turned on from the Home
tab.
1.
Select the Single tab.
NOTE:
If the ISI On/Off buttons are not available, confirm the ISI has been enabled on the
Options tab.
NOTE:
The ISI tab is not available for ml/m, Phased, or Variable Flow Rate protocols.
2.
Select On or Off . The ISI symbol (A) indicates that ISI is on.
Table 10 - 1: 15 mL Purge Configuration Options (ON or OFF)
15 mL Purge ON 15 mL Purge OFF
≥
15 mL Plunger
Retraction
<
15 mL Plunger
Retraction
≥
15 mL Plunger
Retraction
<
15 mL Plunger
Retraction
Arming
Requirements
MUST purge 3.5
mL or more with
Injector in upright
position NOT REQUIRED
to purge
MUST purge 3.5
mL or more ONLY
when retraction
occurs in
Injector’s upright
position NOT REQUIRED
to purge
Auto-Fill remains available for use
Auto-Fill only available in Injector’s
upright position
NOTE: Operator can still choose to
purge prior to arming, if desired, with
plunger retraction of
<
15 mL but
system will not require it
NOTE: Operator can still choose to
purge, if desired, with plunger
retraction of
<
15 mL and/or upon
plunger retraction in Injector’s
downward position