MDS89740KD (PIC-00303)
Revised: 04/21/20
3
1. Turn bench over to reveal holes for mainframes. Underneath the bench (A), there will
be an aluminum mainframe with 4 short legs. Each leg will have a hole punch into it.
2. Next attach aluminum extension legs (B) to aluminum mainframe. Depress the push-
buttons and place into mainframe tube until secured at desired height. Repeat with
three remaining legs. Make sure all four extension legs are installed at the same
height. Also, make sure push-buttons are fully protruded before using.
General Warnings
PLEASE READ CAREFULLY BEFORE USING YOUR MEDLINE BATH BENCH.
To ensure
the safe installation, adjustment, and operation of Bath Bench, these instructions MUST
be followed.
DO NOT install this product without first reading and understanding this instruction
manual.
If you are unable to understand these warnings, cautions, and instructions, contact a
healthcare professional or dealer before attempting to install this equipment. Failure to
follow instructions may result in serious injury.
• Prior to each use check that all joints and fittings on the bath bench are tight.
• Check that all pushbuttons are fully protruded through holes and are properly engaged.
• Make sure all four legs are adjusted evenly and are free of any obstructions prior
to use.
• Check all screws for tightness before EACH use.
• DO NOT place bath bench on uneven surfaces.
• DO NOT use if wobbly, unstable or not level.
• DO NOT exceed user weight capacity of 300 lbs.
• DO NOT twist or turn while seated on bath bench, this may cause frame to bend.
• DO NOT stand on bath bench.
• DO NOT use bath bench for any purpose that it is not intended to be used for.
• Check rubber tips for rips, cracks or wear. If these conditions exist, DO NOT use the tips
and replace IMMEDIATELY. (Rubber tips can be ordered - item MDS89755T.)
Note: Tips On This Product Contain Dry Natural Rubber.