FCEQRHFB (GPI283)
Revision: 02/06/16
2
2. Insert the bottom brackets into the bed’s mounting holes; ensure that the knobs on the bottom brackets are facing outward, as shown in the image
below.
3. Mount the top bracket to the bottom bracket as shown in the image below. Make sure that the hooks are facing outward so that they can connect
to the knobs.
4. Press the locking latch down to secure the top bracket to the bottom bracket. WARNING: Not locking the quick release latch to the bottom bracket
could result in damage to head/board, bed, or personal injury.
HEAD/FOOTBOARD INsTAllATION
1. The head & footboard come with four pre-drilled mounting holes. Locate and install screw inserts into each hole (this may require a rubber mallet).
Use caution as to not damage the surface of the head/footboard. The surface with the screw inserts visible will be the inside of the headboard and
outside for the footboard.
2. Align both holes of the quick release brackets with the top and bottom holes in the head/footboard.
3. Insert and tighten each 40mm pan-head screw through all four holes.
4. Tighten tension knobs located under each mounting tube.
