Carefully slide the mobile rack into the slot until it clicks into place.
Lock the mobile rack in place by pressing on the handle until it audibly clicks into
place. The hard drive will be recognised and can now be used.
Installing a 2.5” SSD drive in a 2.5”/3.5” mobile rack
When installing an SSD drive, follow the fi rst four steps in the previous instructions and
then proceed as follows:
The upper surface of the hard drive should be facing upwards with the contacts
located in the bottom right.
Now insert the right side of the hard drive into the mobile rack.
Tightly hold the hard drive and the mobile rack, turn it over
and use four M3 x 4mm countersunk screws (not supplied) to
screw the hard drive in place using the corresponding screw
holes.
The hard drive decoupler does not need to be replaced
because the hard drive has been suffi ciently secured in
place by the screws.
Carefully slide the mobile rack into the slot until it clicks into place.
Lock the mobile rack in place by pressing on the handle until it audibly clicks into
place. The hard drive will be recognised and can now be used.
Hard drive
30
34045 EN ALDI AUS Content MSN 2006 4786 final.indb 30
34045 EN ALDI AUS Content MSN 2006 4786 final.indb 30
15.12.2017 07:27:53
15.12.2017 07:27:53
