Model 28 Fitting Instructions
6.
Position the Understrap
[f]
centrally on the seat cushion
7.
If the passenger is under 135cm place a Booster Seat or Cushion on top of the Underst
r
ap to comply with child seat safety
legislation
(See back of Instructions for further information)
8.
Position the Back Pad & Body Harness on the seat so that the waist belt will be in line with the waist when the passenger sits
down.
9.
With the harness unfastened at the waist belt
sit the passenger on the understrap / child seat in the most upright position as
possible & bring their arms through the shoulder straps
[d]
.
10.
Now bring the understrap
[f]
up between the legs and loop it back onto the waist belt over the buckle
[h]
.
11.
Connect the waist belt buckle to fasten the harness. Position the buckle centrally at waist level on the passenger.
12.
Adjust all straps to fit tightly yet comfortably by pulling the tail-ends of strapping through the Adjuster Buckles
[i]
.
13.
If using the Houdini Stop Chest Strap
[j]
, attach to Shoulder Straps underneath the Adjuster Buckles
[j].
See instruction provided.
14.
Ensure that the three Comfort Pads
[g]
are in position over the Adjuster Buckles
[i]
on the Shoulder & Under Straps.
15.
Fasten the vehicle safety belt over the top of the Model 28 Harness.
16.
To remove the passenger from the harness - Unfasten the buckle on the waist belt at the centre-front.
1.
If fitting a brand new harness, remove any Rubber Bands & unfasten the two Vertical Fixing Straps
[a]
.
2.
Holding the two Aluminium Bar Buckles
[b]
(attached to the upper section of the Vertical Fixing Straps) place the back pad of the
harness against the front of the seat back & place the Fixing Straps up & over the seat back.
[b] 50mm Aluminium
Bar Buckle
3.
Pass the tail-ends of the two lower sections
of the Vertical Fixing Straps
[a]
(on either side
of the understrap
[f]
), down through the gap
between the seat back & seat cushion.
Nb. The Understrap should remain lying on
the seat cushion.
4.
Now feed the tail-ends of the Fixing straps up through the Aluminium Bar
Buckles
(see diagram [b])
& pull down to tighten around the seat back as
securely as possible.
5.
Each tail end should then be passed through the Sliplock Slide
[c]
to
prevent the Fixing Straps from loosening during transit.
[c] 50mm Sliplok slide
[a] Vertical Fixing Strap
[d] Shoulder Strap
[e] Waist Belt Buckle
[f] Understrap
[h]
40mm Adjuster Buckle
To Tighten Straps
Simply pull the tail-end of
the webbing strap.
The Adjuster will lock the
webbing into position
To Extend Straps
The 40mm Adjuster is slightly spring loaded
to lock the webbing into position.
To release the webbing you need to squeeze
the Adjuster whilst pulling on the lower
webbing strap.
[g]
[j]
[i]
