5595.A
4
Set-up Instructions
1.
Remove the TEMP 3
from the box; leave the black foam inserts inside the cabinet. The
cabinet is setup with the foam inserts for Baxter 1000ml fluid bags.
2.
Locate The Documentor
®
and remove from the shipping box. Attach The Documentor
®
to
the TEMP 3
following the instructions below.
Place the TEMP 3
on its back and remove the two indicated screws.
Align the holes in the TEMP 3
Time/Clock Mounting Bracket to the empty screw
holes. Secure the mounting bracket using the screws removed in step one.
Remove the 3 screws in the back of The Documentor
®
. Attach The Documentor
®
to
Time/Clock Mounting Bracket using these 3 screws.
3.
Locate the wall mounting bracket.
4.
Mount the bracket securely in a convenient place – on a wall or cart. The TEMP 3
loaded
with 6 bags of solution will weigh approximately 30 pounds. When mounting to a wall, care
should be taken to secure the bracket using suitable bolts for the wall material to support a
minimum of 90 lbs.
5.
Move the TEMP 3
to the desired location, check that the power switch is “off” and plug the
power cord into an approved outlet. Turn the unit on.
6.
Using the key switch on the front of the cabinet unlock the doors. Load the labeled bags of
solution into the cabinet through the top door and close the door. The door locks will
automatically lock in approximately 15 seconds. If the door locks prior to closing the door,
unlock the door using the key switch and then close the door again.
Do not remove
these screws.
Front of the TEMP 3
Remove these two
screws
Back Panel