Mediatrix 4102S Скачать руководство пользователя страница 1

Mediatrix 4102S - Hardware Installation Guide

Mediatrix 4102S - Hardware Installation Guide

Mediatrix 4102S - Hardware Installation Guide
2022-05-04
Mediatrix 4102S
DGW 48.5.2718

Download PDF Document

Safety Recommendations and Information

Danger, Warning, Caution, and Note Definitions
Electrical Safety Guidelines
General Safety Practices
Electrostatic Discharge Prevention
Translated Warning Definition

Requirements

Location Requirements
Wiring Guidelines
Mediatrix 4102S Characteristics

Getting Started

Installation Check List
Package Check List
Cleaning Instructions
Mounting Tools and Equipment
Connectors and Indicators

Installing the Mediatrix Unit

Installing the Unit on a Flat Surface
Installing the Unit on the Wall
Connecting the Telephony Cables
Connecting the Mediatrix Unit Using a DHCP Server
Connecting the Mediatrix Unit Using a Static IP address
Verifying the Installation

Cables

FXS Connections (RJ-11)
10/100 Ethernet Connection (RJ-45)

Troubleshooting

Locating the Product Serial Number
Troubleshooting
LED Patterns
RESET/DEFAULT Button
Partial Reset

Performing a Partial Reset

Factory Reset

Performing a Factory Reset
Disabling the Rescue Interface

Standards Compliance and Disclaimers

Federal Communications Commission (FCC) Disclaimer
Supported Standards
Disclaimers

Product Disposal Instructions
DGW Documentation
Copyright Notice

Top

Safety Recommendations and Information

Danger, Warning, Caution, and Note Definitions

Danger: Indicates a hazardous situation which, if not avoided, will result in death or serious injury.
Warning: Indicates a hazardous situation which, if not avoided, could result in death or serious injury.
Caution: Indicates a hazardous situation which, if not avoided, could result in minor or moderate injury or damage to property or equipment.
Note: Indicates important information not related to personal injury.

Top

Electrical Safety Guidelines

Danger: Do not work on the Mediatrix unit, connect or disconnect its cables during periods of lightning.
Danger: Avoid using a telephone (other than a cordless type) during an electrical storm. There may be a remote risk of electric shock from lightning.
Warning: Disconnect all interface cables (including 

 ) before unplugging any power sources from the Mediatrix unit.

FXS,

Warning: Disconnect all interface cables (including 

 ) as well as all power sources connected to the Mediatrix unit before servicing the unit.

FXS,

Warning: This equipment must be installed and maintained by service personnel. Incorrectly connecting this equipment to a general-purpose outlet could 
be hazardous.
Warning: This product relies on the building's installation for short-circuit (overcurrent) protection. Ensure that a fuse or circuit breaker no larger than 120 
VAC, 15 A U.S. (240 VAC, 10 A international) is used on the phase conductors (all current-carrying conductors).
Warning: The unit must be grounded at all times when in use.

Содержание 4102S














Отзывы: