Installation
1. When locating the 782-LT unit, ensure that a clearance
distance of 25mm (1”) is maintained around the unit to
provide sufficient ventilation airflow. Items that could
accidentally block the ventilation grills or impede the
cooling airflow must not be located near the unit.
2. The 782-LT must not be installed where there is a
possibility of exposure to condensation, dripping or
splashing liquids. Containers filled with fluid should not
be located in the vicinity of this unit. Do not fix the 782-
LT to any surface which is a heat source that may cause
the unit to over-heat.
3. Connect the 782-LT unit to the display using an HDMI
cable. Ensure this cable is inserted into the 782’s HDMI
OUTPUT port. All connectors are clearly labelled on the
rear face of the unit.
4. If the 782-LT is to be operated by a user using a
MediaStar Infra-Red (IR) remote control (model 710-IR
(ordered separately), either
a) Ensure the built-in IR receiver on the side of the 782-
LT is visible, or
b) Fit a remote IR receiver module (model 911-4154,
ordered separately). The IR receiver should be mounted
in a visible position, facing away from the screen and be
plugged into the IR RX 3.5mm jack socket in the 782- LT.
If necessary, the 911-4154 cable can be extended up
to 10m using a standard 3.5mm 4 pole male to female
extender cable.
5. Power on the 782-LT by connecting it to the network
using the CAT5 SFTP cable supplied or another
equivalent cable of appropriate length. The 782-LT will
then negotiate a class 0/4 power supply connection with
the PoE power supply equipment. Check that the status
LED is lit.
6. When using HDMI, the 782-LT will automatically
select the highest possible picture resolution that the
display and 782-LT both support. You can configure
a different resolution via the on-board browser
configuration menus.
The LEDs on the network connector will illuminate to
indicate there is a valid network connection. The orange
RJ45 LED indicates a network link has been established,
and the (flashing) green LED shows network activity.
The 782-LT is supplied with DHCP enabled, so by default,
it will negotiate a valid IP address setting with a DHCP
server. If no DHCP server is present, the unit should be
configured with a static IP address. If required, the 782’s
MAC address is printed on the model label on the rear
face of the unit.
Quick Start Guide
MediaStar 782-LT 4K IPTV & Media Player
200-2444 V1 2/8
